Alamo Heights is a small, established town where the housing stock runs older and the lots run mature. That combination means the plumbing underneath those homes has had decades to develop problems: supply lines that have corroded from the inside out, sewer lines that tree roots have found, water heaters that have long since passed their useful life, and fixtures that have been repaired so many times a replacement is the more practical answer. We handle all of it, from a single dripping faucet to a full repipe of a house that has never had its pipes touched.
Whether the call comes from a homeowner who noticed a stain on the ceiling, a landlord with a tenant reporting low pressure, or a property manager trying to keep a unit functional, the process is the same. You describe what is happening, we scope the job on the call, and a price is confirmed before anything is scheduled. We cover Alamo Heights and the surrounding area every day from 7:00 AM to 8:30 PM, including weekends and emergency calls.
Low pressure at a single fixture and low pressure throughout a property are two different problems, and finding the cause starts with telling them apart. A showerhead that barely runs may have a clogged aerator or a cartridge that has worn out. The same symptom at every fixture in the house points somewhere else entirely: a failing pressure regulator, a partially closed main shutoff, or a supply line that has narrowed from mineral buildup over time.
Uneven pressure across a property is its own diagnostic category. One bathroom runs fine while another struggles, or the kitchen loses pressure whenever something else is running. That pattern often points to a restriction in a branch line or a valve that is not fully open. We trace the pressure drop to its source before recommending anything. Water pressure diagnostics are part of how a visit goes, not an add-on.
Hard water accelerates the process. In this region, mineral content is high enough in many areas that scale builds up inside pipes and fixtures over years, reducing the effective diameter of the line. A supply line that was full-bore at installation may be significantly narrowed a decade or two later. Replacing the affected section restores pressure without touching the rest of the system.
A price is confirmed before any work begins. That is not a formality. It is how a visit is structured, because a job that looks straightforward on the phone sometimes turns out to involve more once someone is on site and can see what is behind the wall or under the floor.
What moves a quote is what the fault turns out to be and what has to come apart to reach it. A leaking shutoff valve under a sink is a quick job. A leak inside a wall that has been running long enough to damage the framing behind it is a different scope entirely. We explain what we found and what fixing it involves before proceeding. You decide whether to go ahead with the full picture in front of you.
Getting a quote starts with a call to (830) 445-3954.
Describe what you are seeing, where it is, and when it started. The more specific you can be, the better we can scope the job before arriving. The price you are given covers what the job involves, and if anything changes once we are on site, we tell you before touching it.
Older homes in established neighborhoods generate a specific set of calls. The jobs below come up regularly in a town like this, and each one is worth understanding before you book.
When a sewer line or supply line under a yard or driveway is cracked, collapsed, or root-damaged, the traditional fix involves excavation. Trenchless repair is an alternative where the pipe condition and site allow: a new liner is installed from inside the existing pipe, or a new pipe is pulled through, without digging up the surface above it. It is not the right answer for every situation, but where it fits, it avoids tearing up landscaping or hardscape that would otherwise need to be replaced. We inspect the line first and confirm which approach the situation calls for.
A main line blockage affects every drain in the property at once. Toilets back up, tubs and showers drain slowly, and water may come up in unexpected places. The cause is usually buildup, root intrusion, or a partial collapse somewhere in the run between the house and the city connection. We clear the blockage, inspect the line to understand why it happened, and assess whether the pipe needs repair to prevent it from recurring. Hydro jetting is available for lines where a standard snake will not fully clear the obstruction.
A shower that runs too hot, too cold, or cannot hold a steady temperature usually has a cartridge or valve seat that has worn out. Pressure-balancing valves and thermostatic mixers both fail in ways that make a shower uncomfortable or unusable, and the fix is usually replacing the internal components rather than the whole valve body. We confirm what type of valve is installed, source the correct parts, and carry out the repair with the supply isolated so the rest of the property keeps running.
A shutoff valve that has not been operated in years often seizes when it is finally needed. In an emergency, a valve that will not close means water keeps running until the main is shut. Isolation valves under sinks and behind toilets fail the same way. Replacing them is straightforward work, and it matters most in older homes where the original valves have never been touched. We replace them with valves that operate correctly and confirm they close fully before the job is called done. To see how it all fits together, read the page covering our plumbing services.
When you call, the person who answers knows the trade and can scope the job on the phone. Being local means we're easy to reach and easy to work with. The call is where the job gets scoped, the price gets confirmed, and the visit gets scheduled. Nothing is put on the calendar until you have a clear picture of what the work involves and what it will cost.
Emergency calls are answered and prioritized during our hours, which run every day from 7:00 AM to 8:30 PM. If a pipe has let go, a sewer line has backed up into the property, or there is no hot water in a building, call and describe what is happening. We will get it on the schedule as quickly as the situation allows.
For rental properties and occupied buildings, we work around access constraints. If a tenant needs to be present, or a business needs the work done outside operating hours, mention that when you call and we will work out what the schedule allows. The scope and the price are settled before anyone shows up, so the visit itself runs without surprises.
Repiping is not a routine repair call. It is the right answer when a pattern of failures points to the pipe material itself rather than isolated joints or fittings. Galvanized steel corrodes from the inside and restricts flow over time, eventually discoloring the water. Older copper lines develop pinhole leaks, especially where water chemistry has been working against them for decades. When the same stretch of pipe has failed more than once, or when pressure has dropped across the whole house without a clear single cause, the pipe is usually the problem.
A whole-house repipe in an occupied home is staged to keep the water on as much as possible. The work typically runs section by section, with supply restored to each area before moving to the next. We walk through the staging and the timeline before the job starts so you know what to expect on each day of the work. The new pipe, whether copper or PEX, is pressure-tested before the walls are closed. All drain and pipe work is carried out to code.
Property managers and landlords in Alamo Heights call for the same range of work homeowners do, but the logistics are different. A tenant reports the problem, the manager arranges access, and the invoice goes to the owner or management company. We work with that structure. When you call, tell us whether the property is occupied and who will be providing access, and we will confirm the visit accordingly.
Older rental homes in this town often have plumbing that has been repaired piecemeal over the years. A visit that starts as a drain call sometimes turns up a shutoff valve that needs replacing or a supply line that is overdue for attention. We note what we find and explain the options, but nothing additional is done without approval. No pressure and no gimmicks, just sound, lasting plumbing.
We cover Alamo Heights and the surrounding communities throughout Bexar County. Nearby towns we regularly work in include Olmos Park, Terrell Hills, Castle Hills, and Balcones Heights, as well as properties across the broader San Antonio area. If you are not sure whether your address falls within the service area, call and we will confirm.
Homes in established neighborhoods with mature trees and older pipe materials do follow a pattern. Galvanized supply lines narrow and corrode over time, sewer lines in clay soil get invaded by roots, and original shutoff valves seize when they are finally needed. None of those are emergencies until they are, and a call to describe what you are noticing is the fastest way to find out whether what you have is routine maintenance or something that needs attention soon.
We can describe what was found and what was repaired. If your insurer needs specific information, let us know what they are asking for when you call and we will confirm what we can provide.
We are available every day from 7:00 AM to 8:30 PM. If you need a drain cleared on a weekend or at the edges of those hours, call and we will tell you what is available on the schedule.
Yes. When you call and describe the job, we give you a rate based on what the work most likely involves. If the job turns out to be more complex once we are on site, we tell you before proceeding.
An intermittent leak is often pressure-dependent or related to how a particular fixture is used. We use pressure testing to confirm whether the system is losing water even when the leak is not visible, and we inspect the likely locations based on where the moisture appears. Intermittent leaks are worth catching early because the underlying cause tends to worsen over time.
Yes. When you call, let us know the property is occupied and what access looks like. We confirm the visit time with whoever needs to be present, scope the job before arriving, and carry out the work with as little disruption to the occupant as the job allows. If the work requires isolating the water supply for part of the day, we explain that before scheduling so the tenant knows what to expect.
We find the leak. We fix the line. We test the pressure. You do not need to diagnose the problem before you call. Describing what you are seeing is enough.
Call (830) 445-3954 any day from 7:00 AM to 8:30 PM and we will take it from there.
Drain and sewer work covers these nearby towns as well: Terrell Hills, Kirby, Windcrest, Leon Valley, Live Oak.
For every town we reach, see our list of communities.
From a dripping faucet to a sewer line backup, we handle the full range of residential and commercial plumbing repair and installation throughout Alamo Heights and Bexar County. Every job starts the same way: a call, a scope, and a price before anything is scheduled. The table below covers what each service includes, who it fits, and what is worth knowing before you call.
| Service | What It Covers | Recommended For | Good to Know |
|---|---|---|---|
| Faucet & Fixture Installation | Dripping faucet repair and replacement, Kitchen and bathroom fixture installation, Shower and tub fixture work, Remodel and upgrade connections | Homeowners upgrading fixtures or dealing with drips, leaks, or fixtures that no longer work correctly | A dripping faucet wears out the valve seat over time and wastes water steadily. We repair or replace the fixture and confirm no connections are leaking before the job is called done. |
| Leak Detection & Repair | Pressure testing and electronic detection, Supply line and wall leak repair, Slab leak location and repair, Shutoff valve replacement | Properties with unexplained water damage, high water bills, or visible moisture with no clear source | We locate the leak before opening any wall or floor. Pressure testing narrows the section and electronic detection pinpoints the spot, so the repair is targeted rather than exploratory. |
| Water Heater Repair & Replacement | Tank and tankless unit diagnosis, Heating element and component repair, Full unit replacement and sizing, Gas and water line connections | Households or businesses with no hot water, inconsistent heating, or a unit that is leaking or aging out | We walk through the repair versus replacement decision on the call. If an upgrade from tank to tankless is the right move, we handle the gas or water line connections as part of the installation. |
Call (830) 445-3954 to talk through your plumbing situation, get a scope of the work, and find out what it will cost before anything is put on the schedule.
(830) 445-3954